What to do if there is a large measuring error with Dräger Test Equipment?
If you are getting a large measuring error, there could be a couple of reasons. First, check that the Dräger tube is inserted in the correct Dräger tube holder. Second, the Dräger tube holder might be dirty or loose. Try cleaning the Dräger tube holder, and replace it if necessary.
What to do if Dräger Aerotest Alpha Measuring Instruments show a major measurement fault?
If you're experiencing a major measurement fault with your Dräger Measuring Instruments, there are a few potential causes and solutions: * First, check that the tube is inserted in the correct holder. * Second, the tube holder might be dirty or loose; try cleaning or replacing it. * Finally, a blocked feed system can cause the wrong volumetric flow. To resolve this, unscrew the tube holder from the measuring unit and use compressed air to clear the feed insert from both sides.
Why is the relief pressure deviating from 3 bar in Dräger Measuring Instruments?
If the relief pressure is deviating from 3 bar on your Dräger Measuring Instruments, it indicates an issue with the O pressure regulator 2. The solution is to readjust it to a 3 bar relief pressure.
What to do if the compressed air connection is leaky on Dräger Measuring Instruments?
If you notice a leaky compressed air connection on your Dräger Measuring Instruments, it's likely due to a defective sealing ring. You should check the sealing ring and replace it if necessary.
What to do if the tube is not firmly seated in the tube holder of Dräger Aerotest Alpha?
If the tube isn't firmly seated in the tube holder of your Dräger Measuring Instruments, the tube holder is likely worn. Replace the tube holder to resolve this issue.
How to fix a tube end that is not cleanly scratch marked and broken off in Dräger Aerotest Alpha Measuring Instruments?
If the tube end isn't cleanly scratch marked and broken off in your Dräger Measuring Instruments, this is probably because the tube opener is blunt. Replace the tube opener to fix this.
Why is the compressed gas connection leaky on my Dräger Test Equipment?
A leaky compressed gas connection is often due to a defective sealing ring. Check the sealing ring and replace it if necessary.
What to do if the manual connection cannot be loosened on Dräger Test Equipment?
If the manual connection is stuck, it may be subject to pressure. Bleed the connection to release the pressure.
Why is the safety valve releasing air on my Dräger Test Equipment?
If the safety valve is releasing air, it's possible the piston is leaky. Repair the pressure reducer.
What to do if the dosing unit is leaky in Dräger Test Equipment?
If the dosing unit is leaky, the seal may be defective. Replace the sealing ring to resolve this issue.
General| Measurement Range N2O | 0 - 100% |
|---|---|
| Storage Temperature | -20 - 60 °C |
| Target Gas | O2, CO2, N2O, Anesthetic Agents |
| Measured Gases | CO2 |
| Measurement Range O2 | 0-100% |
| Power Supply | Rechargeable battery |
To Next Page