Dragino RS485-LN - Page 21

User Manual for LoRaWAN End Nodes - RS485-LN – RS485 to LoRaWAN Converter User Manual
So totally there will be 3 uplinks for this sampling, each uplink include 8 bytes DATA
DATA1=RETURN1 Valid Value + the first two of Valid value of RETURN10= 20 20 0a 33 90 41 02 aa
DATA2=3
rd
~ 10
th
byte of Valid value of RETURN10= 05 81 0a 20 20 20 20 2d
DATA3=the rest of Valid value of RETURN10= 30
Notice: In firmware v1.3, the Max bytes has been changed according to the max bytes in different Frequency
Bands for lowest SF. As below:
* For AU915/AS923 bands, ifUplinkDwell time=0, max 51 bytes for each uplink.
*For AU915/AS923 bands, ifUplinkDwell time=0, max 11 bytes for each uplink.
*For US915 band, max 11 bytesfor each uplink.
* For all other bands: max 51 bytes for each uplink.
Below are the uplink payloads:
Page 21 / 38 - last modified by Bei Jinggeng on 2022/07/08 16:50