Dragino RS485-LN - Common AT Command Sequence

User Manual for LoRaWAN End Nodes - RS485-LN – RS485 to LoRaWAN Converter User Manual
More detail AT Command manual can be found at AT Command Manual
5.2 Common AT Command Sequence
5.2.1 Multi-channel ABP mode (Use with SX1301/LG308)
If device has not joined network yet:
• AT+FDR
• AT+NJM=0
• ATZ

If device already joined network:
• AT+NJM=0
• ATZ

5.5.2 Single-channel ABP mode (Use with LG01/LG02)
AT+FDR Reset Parameters to Factory Default, Keys Reserve
AT+NJM=0 Set to ABP mode
Page 32 / 38 - last modified by Bei Jinggeng on 2022/07/08 16:50