TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
REQUIRED ACTION
• Breaking blades.
• Motor will not run.
• Vibration..
• Increase mounting of saw.
• Unsuitable mounting surface.
• Loose table.
• Loose motor mounting.
• Refer to the mounting instructions
in this manual.
• The heavier your work bench is,
the less vibration. A plywood
workbench is not as good as solid
timber.
• Tighten table locking knob. Adjust
table if necessary.
• Tighten mounting screws.
• Defective cable or plug.
• Defective motor.
• Replace defective parts.
• Consult your service agent. Any
attempt to repair this motor may be
dangerous unless the repair is
carried out by a qualified service
agent.
• Wrong tension.
• Over working blade.
• Wrong blade application.
• Twisting blade.
• Adjust blade tension.
• Reduce feed rate.
• Use narrow blades for cutting thin
material or sharp curves, wide
blades for thicker material or
straight cuts.
• Avoid side pressure on blade.
To Next Page
Loading...
