Wireless band will be switched on/off in a
cycle:
⚫ 2.4G (On) and 5G (On) – Default state.
⚫ 2.4G (Off) and 5G (On) – press and release
the button once.
⚫ 2.4G (On) and 5G (Off) – press and release
the button twice.
⚫ 2.4G (Off) and 5G (Off) – press and release
the button three times.
When WPS is enabled in the router’s web
interface, press this button for more than
2seconds to enable WPS pairing mode.
Restore the default settings. Usage: Turn on the
router (ACT LED is blinking). Press gently and
hold for more than 5 seconds. When the ACT
LED blinks rapidly, release the button and the
router will restart with its factory default
configuration.
Connector for a USB 3G/4G modem, storage,
printer or USB Thermometer
To Next Page
Loading...
