Default Pre-Shared Key (PSK) with 13 ASCII characters is provided and
stated on the label pasted on the bottom of VigorAP.
5. Open Wireless Setting (5GHz)>>Security. As with the 2.4GHz band, above,
you should change the SSID name, security method and default wireless
password. Click OK to save the settings. Now, you have finished the basic
configuration of VigorAP.
Note that for the communication, all wireless devices must support the same
encryption bit length and share the same key. If WEP mode is selected, only
one of four preset keys can be selected at one time.
Under System Maintenance you can change the access point’s default
admin password. You should do this immediately in order to prevent users
from accessing the VigorAP’s management interface and changing
settings.
Contacting DrayTek
To Next Page
Loading...
Need help?
General
