14
Start Cleaning
Press the button briefly to start cleaning after the robot is turned on. The robot will
accurately map out a route, methodically clean along the edges and walls, then finish by
cleaning each room in an S-shaped pattern to ensure a thorough job.
Pause/Sleep
When the robot is running, press any button to pause it. If the robot is paused for more
than 10 minutes, it automatically enters sleep mode. All indicators on the robot will turn
off. Press any button on the robot or use the app to wake up the robot.
Note:
• The robot will turn off automatically if left in Sleep Mode for more than 12 hours.
• If the robot is paused and placed onto the base, the current cleaning task will
end.
Do Not Disturb (DND) Mode
When the robot is set to the Do Not Disturb (DND) mode, the robot will be prevented
from resuming cleaning and the power indicator goes out. The DND mode is disabled by
default at the factory. You can use the app to enable the DND mode or modify the DND
period. The DND period is 22:00-8:00 by default.
Note:
• The scheduled cleaning task will be performed on time during the DND period.
• The robot will resume cleanup where it left off after the DND period expires.
Spot Cleaning
When the robot is on standby, press briefly the button to enable the spot cleaning
mode. In this mode, the robot cleans a square-shaped area of 1.5 x 1.5 meters around it
and returns to its starting point once the spot cleaning is completed.