10
EN
1. Remove the protective strips 3. Connect to a power outlet and start charging
2.
Install the side brush
Click
Preparation Before Use
Note:
• Keep the immediate area 1.5 m in front of the base and 0.5 m to its both sides
clear of objects.
• Make sure that no objects might block the signaling area.
Note: Install the side brush until it clicks into place.
Place the base on level ground against the wall and connect it to a power
outlet. Place the robot onto the base to charge. The robot will turn on
automatically and begin charging. It is recommended to fully charge your
robot before rst-time use.
About the Auto-Empty Base
> 0.3 m
> 0.5 m
> 0.5 m
> 1.5 m
To Next Page
Loading...
