11 1211 12
EN EN
Care & Maintenance
3. Wipe the suction inlet with a dry cloth
or wet tissue. Do not rinse the brush
assembly with water.
4. Re-install the brush roller and the
brush roller cover until you hear a click.
Note:
• Clean as needed. Alternating use of the two provided brush rollers is recommended.
• Replacing the brush roller every 3 to 6 months is recommended.
Cleaning the Brush Assembly
1.First, press the brush roller cover
release buttons inwards on both sides to
remove the brush roller cover. Press the
brush roller release button, and the brush
roller handle will pop out. Pull it to take
out the brush roller.
2. Clear any hair and debris caught
on the brush roller with the provided
cleaning brush. Rinse the brush roller
with clean water and dry it completely.
1
2
Care & Maintenance
Tips:
• Turn o the appliance before maintenance. Do not touch the power switch.
• Replace parts if needed. The parts must be replaced by those available from the
manufacturer or its service agent.
• If the vacuum is not used for an extended period, fully charge it, unplugthepower plug,
and store the vacuum in a cool, low-humidity environment away from direct sunlight. To
avoid over-discharge of the battery, charge the vacuum at least once every 3 months.
Cleaning the Used Water Tank and the Filter
1. Press the Used Water Tank release
button, and pull the Used Water Tank
outwards to remove it.
4. Re-install the lter and the Used Water
Tank cover. Then re-install the Used Water
Tank until you hear a click.
1
2
1
2
Note:
• If the lter is dirty, rinse it with clean water and dry it completely before use.
• Replacing the lter every 3 to 6 months is recommended.
Click
Used Water
Tank Cover
Filter
2. Take out the lter from the Used Water
Tank cover. Remove the tank cover and
pour out the wastewater.
3. Rinse the Used Water Tank and the tank
cover with water, the provided cleaning
brush can be used to clean the inner wall
of the tank.
To Next Page
Loading...
