Dreame H12S - How to Use - Modes and Self-Cleaning; Switching Modes; Cleaning the Used Water Tank; One-Press Self-Cleaning

9 109 10
EN EN
How to Use
Press the mode switch to switch among the Auto mode, Turbo mode and the Suction
mode according to your needs.
Switching Modes
Press the Used Water Tank release button to take out the tank. Remove the tank cover
and pour out the used water. Close the tank cover and re-install the tank before use.
Cleaning the Used Water Tank
Note: The self-cleaning function can be enabled only when the appliance is being charged and the
battery level is more than 20%.
1. Place the appliance back onto the base while you 󶀄nish cleaning. Ensure that the
water in the Clean Water Tank is su󶀆cient for self-cleaning.
2. Brie󶀅y press the self-cleaning button on the top of the handle to start/stop self-
cleaning.
3. Please empty the Used Water Tank after self-cleaning is completed and drying mode
has been engaged. Press the button to exit the drying mode.
One-Press Self-Cleaning
1
2
4
3
1.
Press and hold self-cleaning button for 3 seconds to activate drying mode.
2.
The appliance will be charged once drying is completed.
Drying Mode
Note:
• After self-cleaning is complete, promptly clean the Used Water Tank. Clean the charging base if
there are any stains left on the base.
• If cleaning the brush roller manually, please air-dry it thoroughly or dry it by using drying mode
several times to ensure a good drying e󶀃ect.
How to Use