7 87 8
EN EN
Charging
1.
Place the charging baseagainst a wallon level ground and connect it to a
powersource. Fully charge the appliance before rst use.
2.
Place the appliance on the charging base. When charging, the number on the display
screen represents the current battery level as a percentage. When the number reaches
100, the battery is fully charged.
Note:
• If there is no operation within 10 minutes of being fully charged, the vacuum will enter sleep
mode. Please restart the appliance if you need to use it.
• To extend the battery life time, the battery keeps cooling down for about one hour automatically
after you have used the appliance for a long time.
How to Use
Press the Clean Water Tank release button and pull the tank outwards to remove it.
Remove the cover of the Clean Water Tank and ll the tank with clean water. Install the
Clean Water Tankand ensureit clicks into place.
Filling the Clean Water Tank
Adding Cleaning Fluid
1
2
Gently step on the brush cover and recline the appliance backwards. Press the power
switch to start operating.
Note:
• Do not vacuum any foamy liquids.
• The appliance will be suspended in the upright position while running.
• The appliance is suitable for cleaning oors, marble, tiles and other hard surfaces.
• Do not recline the appliance backwards more than 140° to prevent the appliance from leaking water.
• When the appliance isin operation,do not liftit o the groundorlay it at.Doing so may cause the
usedwatertoow into the motor.
Starting Cleaning
＜140°
For better cleaning performance, it is recommended to add 0.34 oz (10 ml) detergent
with the bottle cap into the full Clean Water Tank, then shake gently and evenly for use.
Note: Do not add any liquids other than the ocially-approved cleaner. The cleaner can
be available on the ocial online store.
WARNING
: To reduce the risk of re and electric shock due to internal component
damage, use only dreame AWH10 cleaning uid intended for use with the appliance.
To Next Page
Loading...
