1
2
57 58
EN EN
Care and Maintenance
press the brush roller release
roller will pop out. Pull the handle to
take out the brush roller.
2. Clean out any hair and debris tangled
on the brush roller with the provided
cleaning brush. Rinse the brush roller
with clean water and dry it completely.
dust cup with water.
completely before use.
* Replacing the brush roller every 3 to 6 months is recommended.
1
2
3. Wipe the suction inlet with a dry cloth
or wet tissue. Do not rinse the brush
assembly with water.
4. After cleaning the brush roller, re-install
the brush roller and the brush roller cover.
You will hear a click to indicate that they
are installed in place.
Cleaning the Dust Cup Assembly
1. Press the dust cup release button and
remove the cup. assembly from the dust cup, then empty
the cup.
* Cleaning the dust cup after each use or after the amount of dust in the cup reaches the MAX line is
recommended.
Note: To reduce the risk
of electric shock or injury,
do not rinse the cyclone
assembly with water.
Remove the Used Water Tank, wipe the tube and the dirt
sensor with a wet cloth before use.
Cleaning the Tube and the Dirt Sensor Cleaning the Brush Assembly
To Next Page
Loading...
Need help?
General
