42
MATERIALS
Observe all provided
warnings and safety
instructions when using the Dremel LC40.
Failure to do so may result in fire,
equipment damage, property damage or
personal injury.
Never engrave or cut any
unknown material. Only
engrave materials recommended by the
manufacturer. The vaporization/melting of
many materials, including but not limited
to PVC and polycarbonates, can give off
hazardous fumes. Always refer to the Safety
Data Sheet (SDS) from the material
manufacturer to determine the response of
any work material to extreme heat
(burning/fire hazard) to prevent hazards.
Click to select a material from the list of
Dremel provided defaults, or choose “more”
to add/delete/edit the list of favorite
materials. Use the star to denote a default
material that will be saved and used for all
jobs, until changed. The settings that are
populated when a material is selected will
be applied to all files brought in, unless
edited in the print settings box, or changed
in the materials list.
TIME
Click to calculate a rough estimate of how
long the job will take to complete.
OPTIONS
Displays more advanced settings and
defaults.
DREMEL LC40 CONTROL SOFTWARE
To Next Page
Loading...
