80
Send the job file it to the laser so the laser can perform its system checks. From the
Dremel LC40 Control Laser Software toolbar click "START" to run the job.
Step 5: System Check
Review the screen to make sure that all
four system icons are white indicating the
system is ready to run.
If any icons are red, the laser will notify
you that these systems need to be fixed
before beginning the job. A “?” next to
the appropriate line item will help to
diagnose and correct each error.
Refer to Touch Screen information
starting on page 19 for additional
information.
OPERATING THE LASER CUTTER
Step 4: Send the Job to the Laser
Close the laser lid. The “Run Perimeter” feature on the LCD laser screen or in the
Dremel LC40 Control software can be utilized to ensure that the work piece and the
design are aligned. The “Run Perimeter” feature moves the head of the laser around
the perimeter of the job as it is set up in the software.
To Next Page
Loading...
Need help?
General
