15
Section 2: Access Codes
Duress Codes
If the “Duress” user option is enabled, the code will become a Duress
code. When this code is entered, the system will send a duress signal to
the monitoring station. Make sure that the Arm and Disarm user options
are also enabled for this code.
One-time Use Codes
If the “One-time Use” option is enabled, the code will become a One-time
Use code. The code can be used to disarm assigned partitions. When a
user arms the system using a One-Time Use code, the panel will erase the
code once the Exit Delay expires; after this time, the code cannot be used
again. Make sure that the Arm and Disarm user options are also enabled
for this code.
Log Only Codes
A “Log Only” code will onlycreate an entry in the event buffer when
entered at a keypad. Example: a log-only code may be used by a guard to
record the time that they checked each area of the premises.
To create a log-only code, disable all the access code options for the code.
2.7 Installer Programmed Codes
These are access codes that are programmed by your installer. Talk to
your installer for more information regarding these codes.
• Second Master Code: This code has the same properties as the
System Grand Master code. Only your installer can program this
code.
• Walk Test Code: The Walk Test code is used to access to the walk test
mode. See Section 5.1 “Walk Test” for instructions on performing a
walk test.
• Guard Code: This code is only valid when a partition is disarmed
and for a programmed amount of time after a partition is armed
using the Guard code. Only your installer can program the Guard
code.
To Next Page
Loading...
Need help?
General
