19
Section 3: System Administration
3.7 [*][7] Command Outputs 1-8
Keypad Command: [*][7][1-8]
These outputs must be programmed by your installer. Up to eight
command outputs can be added to your system. These outputs will operate
sets of lights, door strikes and various other items depending on what
you and your installer have decided to add to your system.
To activate the output, enter [*] [7] followed by the output number, from
1-8. For more information regarding the [*] [7] command outputs, please
ask your installer.
3.8 Keypad Control
Keypad Command: [*][6][Master Code]
The brightness of the keypad backlighting and the contrast of the keypad
display can be adjusted. To alter the brightness and contrast from their
default settings, perform the following:
1. Press [*] [6], then enter a valid access code which has the “System
Master” or “Supervisor” option enabled. The display “System
Functions Menu” should appear.
2. Use the arrow keys (< >) to scroll to the message “Keypad Setup.”
Press [*].
3. The display should read “Bright Control.” Press [*]. Use the arrow
keys to scroll through eight different settings of backlighting levels
and press [*] to select the desired setting.
4. Use the arrow keys to scroll to “Contrast Control.” Press [*].Use the
arrow keys to scroll through eight different settings of display
contrast and press [*] to select the desired setting.
Press [#] when you have finished programming to return the partition to
its normal disarmed state.
3.9 Downloading Options
Keypad Command: [Master Code][9]
Enable DLS Window
This option will allow the downloading computer to access the system.
This DLS window will last for 60 minutes after the option is selected. This
function can only be disabled by your installer. To enable downloading,
perform the following:
1. Enter a System Master code and press [9]. The display will read
“System Master Menu.”
2. Use the keypad arrow keys (< >) to scroll to the display “Enable DLS
Window.” Press [*]. Downloading will be enabled for one hour.
3. To exit the menu, press [#].
To Next Page
Loading...
Need help?
General
