DSC Power Series PC1616 PC1832 PC1864 System Manual
https://alpha.adt.com/help/61[11/12/2018 9:40:17 PM]
Return to Top
When the keypad is loaned to global mode (pressing and holding the [#] key), you will see a Global
Partition Status screen. This shows basic status for up to 8 partitions, depending on the configuration of
your system.
Each partition is identified by a number. Below each number is the current status of that partition.
A - Partition is Armed
N - Partition is Not Ready to Arm
R - Partition is Ready to Arm
! - Partition is in Alarmed
- - Partition is Not Enabled
Sensor Reset
Certain sensors, after having detected an alarm condition, require a Reset to exit the alarm condition (i.e.
glassbreak sensors, smoke detectors, etc.). Ask your alarm company if this function is required on your
system.
To reset the detectors, press and hold the Reset key for 2 seconds or press [*][7][2].
If a sensor fails to reset, it may still be detecting an alarm condition. If the sensor reset is successful, the
alarm is canceled. If unsuccessful, the alarm will reactivate or continue.
To Previous Page
Loading...
Need help?
General
