To Next Page

To Previous Page

DSC Power Series PC1616 PC1832 PC1864 System Manual

https://alpha.adt.com/help/61[11/12/2018 9:40:17 PM]

Duress Codes (Access Codes 33 & 34) - Duress codes 33 and 34 are standard User Codes that will

transmit the Duress Reporting Code whenever the code is entered to perform any function on the

system.

Note: Duress codes are not valid when entering [*][5], [*][6] or [*][8] sections. No codes can be

programmed as a duplicate of another code. Duress codes cannot be programmed as a duplicate or as a

“Code + 1”.

User Code Attributes

The default attributes of a new code will be the attributes of the code used to enter [*][5] whether it is a

new code or an existing code being programmed. System Master (Code 40) has Partition Access for all

partitions, as well as Attributes 3-4 ON by default.

Note: These attributes are not changeable.

Inherent Attributes (all codes except installer and maintenance)

Arm/Disarm - Any Access Code with Partition Access enabled will be valid for arming and disarming that

partition.

Command Outputs([*][7][1], [*][7][2], [*][7][3], and [*][7][4]) - If these outputs require Access Code

entry, any Access Code with Partition Access will be valid for performing the [*][7][1-4][Access Code]

functions on that partition.

Programmable Attributes ([*][5][Master/Supervisor Code][9][Code]).

1. For Future Use

2. For Future Use

3. Zone Bypassing Enabled

4. ESCORT Access

5. Downlook Remote Trigger to Phone Number 1

6. Downlook Remote Trigger to Phone Number 2

7. Bell Squawk upon Arming/Disarming

8. One Time Use Code

Note: Attributes 5 and 6 cannot be enabled on the same access code.

Bell Squawk Attribute

This attribute is used to determine whether an access code should generate an arming/disarming Bell

Squawk upon entry of the code for Away arming. The Wireless Keys with access codes associated with

them may generate Arming/Disarming Bell squawks. If desired, this option may be used with codes that

are manually entered. Please contact your installer to have this programmed.

DSC Power Series User Manual

Other manuals for DSC Power Series