Section 2: Installation
Tamper Switch
The panel includes a tamper switch under the back battery cover. If the battery cover is removed while the system is dis-
armed, the tamper condition must be cleared before arming is permitted. If the battery cover is removed while the system is
armed, the bell sounds, a system tamper is logged and communicated to the central monitoring station, and a system tem-
per trouble is displayed in the Trouble menu.
2.3 Enrolling Wireless PowerG Security Devices
Device enrollment and configuration is done using the installer portal. Refer to the wireless device programming descrip-
tions on page 1.
Wireless devices are enrolled using one of the following methods:
l Manually entering a device-specific serial number then configuring the available options.
l Using auto enrollment.
To auto enroll:
1. Enable auto enroll using the installer portal.
2. Power up the wireless device and press the Enroll button until the on-board LED lights steady. The serial number is
displayed.
3. Confirm you want to enroll the device then configure the available options.
4. Submit the settings to finish enrollment.
5. Continue the above process until all devices are enrolled.
The wireless devices in the table below each have a dedicated Enroll button, located on the circuit board inside the plastic
casing. A Phillips screw must be removed on most devices to gain access. Refer to the installation instructions provided
with the device for more information.
PGx901 Indoor siren PGx924 Curtain motion detector
PGx904 PIR/Pet Immune motion detector PGx926 Smoke detector
PGx914 PIR/Pet Immune motion detector PGx935 Shock detector and magnetic contact
PGx905 Temperature detector PGx944 Tower Cam motion detector
PGx911 Outdoor siren PGx945 Magnetic contact with Aux.
PGx913
Carbon Monoxide detector
Note: enrolls automatically on power-up
PGx974 Mirror PIR with anti-masking
PGx912 Glassbreak detector PGx975 Magnetic contact (vanishing)
PGx916 Smoke and heat detector PGx984 Mirror PIR motion detector
PGx920
Wireless repeater
Note: hold Enrollbutton until red and green LEDs light steady
PGx985 Flood detector
PGx922 Glassbreak detector PGx994 Outdoor PIR motion detector
To enroll wireless keys:
PGx929/PGx939 4-button wireless key Press and hold [*] button until LED lights steady then release.
PGx949 2-button wireless key Press and hold unlock button until LED lights steady then release.
PGx938 Panic key Press and hold button untilLED lights steady then release.
- 12 -
To Next Page
Loading...