DSC WS900-19UL - Wireless PIR (no CAM) Configurations

Section 4: Programming Options
period is reported onece the timer expires. No Delay causes
the device to report an alarm each time the detector is
tripped.
Default: Not Active
Valid
range:
Not Active, No Delay, 5 Second Delay, 15 Second Delay, 30
Second Delay, 1 Minute Delay, 5 Minute Delay, 10 Minute
Delay, 20 Minute Delay, 60 Minute Delay
Event Counter
This option is used to set the number of alarm events
required to activate the alarm.
Default: Low
Valid range: Low/High
Image Brightness
This option is used to lighten or darken the camera image.
Default: 0
Valid range: -3, -2, -1, 0, 1, 2, 3
Image Contrast
This option is used to lighten or darken the contrast of the
camera image.
Default: o
Valid range: -3, -2, -1, 0, 1, 2, 3
Color
When this option is enabled, the camera captures color
images. When disabled, the camera captures black and
white images.
Default: Enabled
Valid range: Enabled/Disabled
High Resolution
When this option is enabled, the camera captures high res-
olution images (320 x 240 dpi). When disabled, image res-
olution is 160 x 128 dpi.
Default: Enabled
Valid range: Enabled/Disabled
Normal Quality
When this option is enabled, the camera captures lower res-
olution images (160 x 128 dpi).
Default: Disabled
Valid range: Enabled/Disabled
Audio (mic)
This option is used to enable/disable the built-in microphone
on the device.
Default: Disabled
Valid range: Enabled/Disabled
4.6.10 Wireless PIR (NO CAM) Con-
figurations
The following sections are used to program wireless motion
detectors.
Device Enable/Disable
This option is used to enable and disable the wireless
device.
Default: Enabled
Valid range: Enabled/Disabled
Device Partition Assignment
This option is used to enable and disable the wireless
device.
Default: Enabled
Valid range: 1
Chime Tone
This option is used to select the tone emitted by the device
when the zone is tripped.
Default: Beeps
Valid range: Beeps, Bing Bing, Ding Dong, Alarm Tone
Zone Type
This option is used to program a zone type for the device.
Default: Follower
Valid
range:
Instant, Interior, Follower,Interior Stay/Away, Delay
Stay/Away, 24 Hour Supervisory Buzzer, 24 Hour Non-
Alarm
Device Label
This option is used to program a custom label for the wire-
less device.
Default: Zone ZZZ
Valid range: 32 character ASCII
- 38 -