EasyManuals Logo

DTS 800 User Manual

DTS 800
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
7
Installation
Remember there are specific standards that have to be strictly followed regarding the safety of electrical installations and
automatic gates and doors.
As well as the legal requirements and standards that must be adhered to, please take note of the following points to ensure
maximum safety and reliability of your installation.
3.1) Prior to installing check the surrounding environment. Carefully evaluate any hazards there could be from physical damage
(transiting vehicles, parts of trees falling etc.), possible contact with foreign bodies (insects, leaves, etc.). Flooding hazards
or any others exceptional events.
3.2) Check that the main voltage is the same as that given on the rating plate and in this manual.
3.3) Check that there is suitable electrical protection against short circuit/power spikes and proper earth on the main supply.
Remember the unit has mains voltage running through it (electrocution hazards, fire hazards).
3.4) Take care with the control unit, parts may be subject to damage if abused.
3.5) Make sure you have all the necessary materials and that they are suitable for this kind of use.
3.6) Read all the instructions thoroughly and make sure they are understood before attempting to install the DTS600/800.
3.7) Before starting the installation, carefully analyse all the risks relating to automating the door. Verify that the door to be
automated is in a sound condition and that the mechanisms are in good working order, observe the safety margins and
minimum distances.
3.8) Evaluate with particular care the safety devices to be installed and where to install them, always install an emergency stop
device for interruption of power to the opener if required.
3.9) Once the risks have been analysed, install the DTS600/800 opener and relative safety devices, emergency stop and
photoelectric cells.
Important: Infra Red Beams must be fitted if auto close is activated.
3.10) When installing the DTS600/800 opener, strictly follow all the instructions given in the instruction manual. If some points
or procedures in this manual are not very clear, do not install until all doubts have been cleared up with our technical
department.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the DTS 800 and is the answer not in the manual?

DTS 800 Specifications

General IconGeneral
BrandDTS
Model800
CategoryGarage Door Opener
LanguageEnglish

Related product manuals