18- REMOVING / REPLACING THE ROTATING GOBOS
EVO uses a mechanical system which allows the fixture's gobos to be removed
without the use of special tools.
When replacing gobos, ensure that the projector is switched off.
Open the projector housing as described on page 31 and pull out the gobo holder on
the rotating gobo wheel as showed in the picture below.
REPLACEMENT GOBOS
Replacement gobos must be made only of glass with special high temperature
treatment. Please refer to an authorised D.T.S. dealer for details.
Gobo dimensions are as follows:
Rotating gobos
ø external (ED) = 13.93 mm + 0 / - 0,1 mm
ø of image with defined edge (ID) = 9.0 mm
thickness = from 0.2 to 3 mm (see catalogue)
Max thickness 3 mm
Coated side
When an object is held up the coated side of the glass gobo
there is no space between the object and its reflection.
Uncoated side
When an object is held up the uncoated side of the glass gobo
there is a space between the object and its reflection.
Load with coated surface toward the light source.
To Next Page
Loading...
