NOTE:
Be sure to follow specific instructions included with your amplifier installation kit
(not included with this amplifier). The information below should be used as a general
guideline only.
Power Wire (+12V)
s $ISCONNECT NEGATIVE BATTERY TERMINAL BEFORE PROCEEDING #ONSULT A QUALIFIED
technician for instructions if you are unsure.
s 0LAN WIRE ROUTING BEFORE CUTTING ANY WIRES TO LENGTH "EGIN BY ROUTING THE POWER
6 WIRE FROM THE BATTERY TO THE AMPLIFIER LOCATION 5SE A GROMMET WHEN RUNNING
WIRES THROUGH THE FIREWALL OR METAL OPENINGS !VOID RUNNING THE POWER WIRE NEAR
EXISTING VEHICLE WIRING TO PREVENT INDUCED NOISE FROM ENTERING THE AUDIO SYSTEM
s 5SE EXTREME CAUTION WHEN DRILLING HOLES TO AVOID DAMAGING FUEL LINES OR EXISTING
VEHICLE WIRING
s 4HE 6 WIRE -534 BE FUSED WITHIN OF THE BATTERY FOR PROTECTION OF THE VEHICLES
electrical system.
Ground Wire (GND)
s 4HE AMPLIFIER GROUND WIRE SHOULD BE AS SHORT AS POSSIBLE NO MORE THAN OR
METER #HOOSE A CLEAN UNPAINTED SECTION OF METAL OR THE VEHICLE CHASSIS WHEN
ATTACHING THE GROUND CONNECTION "E SURE TO CLEAN THE AREA OF ANY DIRT OR GREASE
Remote Turn-on Wire (REM)
s 4HE REMOTE TURNON WIRE CONNECTS TO THE HEAD UNITgS AMPLIFIER TURNON LEAD OR
POWER ANTENNA OUTPUT
Speaker Wires
s #HOOSE ADEQUATE GAUGE SPEAKER WIRE DEPENDING ON YOUR EXACT AMPLIFIERSPEAKER
COMBINATION "E SURE TO OBSERVE POLARITY WHEN CONNECTING
s $O NOT GROUND ANY SPEAKER WIRES OR CONNECT ANY SPEAKER WIRES TOGETHER
Input Signal
s 4HE AMPLIFIERgS INPUT SIGNAL CONNECTS TO THE HEAD UNITgS LOW LEVEL 2#! OR HIGH LEVEL
SPEAKER WIRE OUTPUTS
s ,OW LEVEL INPUT SIGNALS DELIVER THE BEST PERFORMANCE )F UNAVAILABLE USE THE HIGH
LEVEL INPUTS WHEN INTERFACING WITH FACTORY HEAD UNIT FOR INSTANCE
CAUTION
s $O NOT USE BOTH LOW AND HIGH LEVEL INPUTS AT THE SAME TIME #ONNECT ONLY ONE OR THE
other.
s +EEP LOW LEVEL INPUTS AWAY FROM ANY POWER WIRES TO AVOID ENGINE NOISE
s .EVER RUN ANY WIRES UNDERNEATH OR OUTSIDE THE VEHICLE
INSTALLATION
Connection Descriptions
To Next Page
Loading...
