27
CM1 cycle:
First step: Turn on user’s customized zone and color.
Second step: Turn on user’s customized zone and color in breathe mode.
Third step: Turn off CM1.
CM2 cycle:
First step: Turn on user’s customized zone and color.
Second step: Turn on user’s customized zone and color in breathe mode.
Third step: Turn off CM2.
Erase all LED light
Adjust color red
(R) , 10 levels.
Adjust color green (G), 10 levels.
Color palette
REC over, finish recording
Adjust color blue (B), 10 levels.
RGB LED Zone Customization Modes
Fn + Alt + G
Fn + Alt + B
Fn + Alt + Caps Lock (REC)
Caps Lock + Z
Caps Lock + X
Caps Lock + C
Caps Lock + Spacebar
Caps Lock + V
Caps Lock + Left Shift
Press for 3 seconds until the G (CM1) and B (CM2) keys light up,
choose the layer for setting, press it again and start recording.
To Next Page
Loading...
