Duke FLEXBAKE 5 - Page 15

15
Owner’s Manual for Duke Flexbake 5
TM
Proof and Bake Oven with WiFi Connectivity
INSTALLATIONcontinued
PROOF AND BAKE OVEN STARTUP
WARNING
ELECTRICAL SHOCK HAZARD.
TASKS MUST BE PERFORMED BY A
QUALIFIED SERVICE TECHNICIAN OR
ELECTRICIAN.
STEP 1 Have a qualied service technician or electrician
connect the Proof and Bake Oven to the mains supply.
STEP 2 Turn control power on to the unit with the control
power switch on the left side of the control panel. Boot Screen
is displayed and automatically transitions to the Main Screen.
STEP 3 Turn the oven ON by touching the
button
located at the lower left of the touch screen. The buttons and
screen will turn to BLUE background. The Oven lights will turn
on and start preheating.
STEP 4 Select a proof and bake recipe (Full Bake) and verify
operation. The unit will automatically begin a conditioning
cycle. Allow approximately 30 minutes for it to complete.
When the conditioning cycle is complete, the display will
change to the Oven Recipe Ready to Start screen.
STEP 5 Check the door seal and make sure the door closes
completely.
STEP 6 If the unit does not power up correctly or if the door
does not close and seal properly, call Duke for assistance.
Figure: Main Screen
AUDIBLE ALARMS
The Proof and Bake has various audible alarms.
1 chirp Keystroke acknowledgment
3 triple chirps Oven ready (up to temperature) notication
Continuous rapid beeps (continuous until cleared) Oven door open alarm
2 long beeps (continuous until cleared) Oven end of cycle
Triple beeps (continuous until cleared with door cycle or
touching “Add Cheese NOW” message)
Add Cheese Time Alarm (2 min. prior to end of
Proof Cycle)
3 triple chirps (repeating every minute until cleared) Reminder: Start Bake
3 short beeps (with message persistent for 1 minute) 20 min. Alarm (prior to end of bake, alert to retard
next load of bread)
3 short beeps End of bake 2 min alarm