14 … 26
M • Edition 07.20 • Nr. 270 173
Adjusting the parameter setting
To adapt or change parameters is done for all DUNGS devices according to the same procedure.
However, the devices dier in the activation of new values.
Please refer to the corresponding operating and installation instructions.
The ability to change parameters is restricted by a password hierarchy:
Password levels
Level 5: Operator / no password / no change authorization
Level 4: Service / password / limited change authorization
Level 3: OEM / Password / full editing rights
Level 2: OEM expert / password / full editing rights incl. expansion variable upper and lower limits
Level 1: DUNGS / password / developer level
Open „Settings MPA“ (also for VPM)
Select „Access Level“
Enter password
Select Access Level
Conrm with OK
8.1 Change of access level
To Next Page
Loading...
Need help?
General
