Dungs VisionBox - Copy of a existing parameter set

14 … 26
M • Edition 07.20 • Nr. 270 173
15 … 26



Conrm change of the access level by
pressing the RESET button on the MPA /
VPM
Change of the access level successful,
complete with „OK“
Open „Settings MPA“ (also for VPM)
Select „Load conguration“
If the VisionBox program is connected to a
MPA/VPM the dierences between the actual
parameter setting of the MPA/VPM and the
loaded conguration will be shown with yellow
marked cells.
8.2 Copy of a existing parameter set