1.7 FILLING THE MACHINE
Two tanks contain the washing liquid and they both
have always to be at the same level.
Filling can be performed as follows:
1.
by pouring water in from a jug (figure “1.9”);
2.
removing the tanks and placing them under
a tap.
A
620 steam model is equipped with a level
gauge for water (1) ensuring easy control of
the residual active solution in the tank.
Fill tank “A” only with water and Hydroscale in
the correct dilution
1
Figure 1.7
1.9
WARNING
The manufacturer declines any liability for damage caused to the
machine,
flooring of any kind, including carpets,
deriving from the use of
non conforming detergents or products (see “1.19 WARRANTY” )
DUPLEX STEAM 340, 420 and 620
WARNING
With DUPLEX STEAM model detergents must not be used.
The use of detergents will irreparably damage the equipment.
the manufacturer shall not be liable for damage caused to the machine deriving from
the use of any other type of detergent or non conforming
products (see paragraph
“1.19 WARRANTY”).
To Next Page
Loading...
