1.2 GENERAL WARNINGS
MAINS CABLE WITH PLUG
Check the mains cable regularly to see if there is any sign of damage: cracking, peeling, ageing.
• If the mains cable is damaged, replace it before using the machine.
• Use a cable of the same type used by the Manufacturer, certified according to “ENEC”
European standards
• Qualified personnel must perform cable replacement.
AVOID ANY CONTACT OF THE MAINS CABLE WITH THE BRUSHES
• Always work with the cable behind you as to not get it near the machine during use
• Should the mains cable get caught under the machine brushes, DO NOT ATTEMPT TO
GET
IT OUT WHILE THE MACHINE IS WORKING. Move the handle upwards to the
vertical position to stop the machine immediately and move the slide switch to the rest
position then remove the plug from the socket outlet
• Only the remove the cable and check for damage if it is damaged in any way the cable
must be replaced before the machine is used again
OTHER WARNINGS
• Whenever the machine is in the rest position check that it does not rest on the brushes but
that it is supported by the four wheels that come down automatically when the slide
switch is in the “RT” rest position (see figure “1.10”). If this not the case, the machine
weight could warp the brushes.
• Do not pour water or liquids directly onto the machine.
• Unplug the mains cable from the power socket before any maintenance.
• Store the machine in a closed and dry place after use.
• The machine is designed and constructed exclusively to clean floors. Any other use is
considered improper.
• When the machine is no longer able to operate after years of work, it must be dismantled
and rendered unusable for disposal in compliance with the indications on paragraph “1.20
DISPOSAL AND RECYCLING”.
To Next Page
Loading...