1.11 CLEANING EXTREMELY DIRTY FLOORS
When it is necessary to thoroughly wash floors with ingrained dirt it is advisable to switch off
the “mop-up”.
In such conditions the water left on the floor will serve to further soften the dirt and this will be
subsequently removed by an energetic brushing action together with the steam.
To deactivate the recovery device, proceed as follows:
1.
Stop the machine (if in operation);
2.
Position the MOP-UP lever (figure “1.10”) upwards.
Then, by positioning the MOP-UP lever downwards the automatic dirty water recovery system
will be switched back on.
IMPORTANT!
When using this procedure on carpets extra care must
be taken not to soak the floor.
USING THE STEAM MODELS
1.
Press the main switch on the boiler (A) (figure “1.16”).
The switch will light up when the handle is
lowered, and after approximately 1 minute, the
boiler will reach the operating temperature.
2.
Operate the lever positioned under the handle
every time that floor needs additional wetting.
3.
Slowly lower the handle on one of the sides. The
machine will start up and the revolving brushes will
start scrubbing the floor.
4.
Move the machine forwards following the same washing
track.
5.
Dispense the liquid by activating the lever underneath the
handle at brief intervals and only when the machine is moving
forwards, taking care not to flood the floor.
1.17
To Next Page
Loading...
