HINTS ON THE “STEAM” GENERATOR OPERATION
The boiler starts heating up when the main switch (figure “1.16”) on the steam generator is
turned on (red LED indicator light switched on).
The heating of the boiler is controlled by one thermostat which deactivates the operation in
case of a fault.
A thermofuse limiting device interrupts boiler operation in the event of thermostat malfunctions.
Do not let the clean water tank become empty, this will cause the pump to overheat. Once the
overheating reaches a critical level, a thermostat incorporated into the pump will intervene and
immediately stop its operation. The pump will then have to cool down which could take 20/30
minutes, after this time it will automatically reset.
It is always recommended to turn off the pump using the main switch in case of no water in the
tank.
WARNING
Do NOT touch the steam spray nozzles or the metal panels of
the machine with your hands due to the high temperatures
that they reach during
operation.
To Next Page
Loading...
