Page 21
CREASE SKEW ADJUSTMENT
Skew adjustment is needed only when folding finished paper is skew.
1. The crease module has 2 thumbscrews. Loosen thumbscrew on operator side only.
Figure 5
2. Loosen lock nut.
3. Turn adjustment screw to ½ turns.
Figure 6
4. Make sure the crease module is against the adjustment screw and press “Start” to test 1 sheet of paper.
5. Check fold to see if more adjustment needed. If skew is worst turn thumbscrew opposite direction. If
more adjustment needed, repeat step 3 and 4.
6. If skew has been corrected, turn the “Lock Nut” to hold adjustment skew in position.
Loosen thumbscrew
To Next Page
Loading...
