Need help?Do you have a question about the Duplo DocuCutter DPC-400 and is the answer not in the manual?
General| Cutting Width | 400 mm |
|---|---|
| Cutting Speed | Up to 8 sheets per minute (8.5" x 11") |
| Power Supply | AC 100-240V, 50/60Hz |
| Dimensions | 21.3" (W) x 20.5" (D) x 14.2" (H) |
| Weight | 66.1 lbs |
| Maximum Cutting Length | 400 mm |
| Cutting Thickness | 5 mm |
| Slits | Variable |
| Cuts | Variable |
| Creases | Variable |
General safety rules and precautions for operating the machine.
Safety precautions before performing maintenance.
Guidance on preventing accidents through operator caution.
Lists DOs and DON'Ts for safe operation and maintenance.
Explains the machine's function for cutting and creasing.
Explains safety symbols and their meanings used in the manual.
Details the manufacturer and machine specifications on the nameplate.
Lists precautions before, during, and after operation.
Lists included parts with names, photos, and quantities.
Overview of key components and installation process.
Specifies requirements for installation like space, environment, and air supply.
Instructions on how to position and level the cutter.
Details the process for installing and adjusting the compressed air system.
Step-by-step guide for installing cutting blades.
Instructions for installing the creasing wheel.
Steps to power on the machine and its initialization.
Procedure for safely powering down the machine.
Explains how to navigate the main screen and its functions.
Details the functions and parameters within the test screen.
Configuration of tools, speeds, and acceleration parameters.
Adjustments for wheel delay and angle parameters.
Adjustments for X-axis calibration and tool offsets.
Adjustments for Y-axis calibration and tool offsets.
Configuration for cursor position, angle, and length.
Adjustments for knife compensation and wheel offset.
Configuration for auto-return, pump, and auto-feed.
Settings for password input and extended setup.
Configuration of IP address, material type, and suction.
Settings for rolling repeat and feed length adjustments.
Options for auto repeat function and factory reset.
Procedures for calibrating X and Y axis tool offsets.
Adjusting knife and knife1 compensation for corner shapes.
Fine-tuning wheel offset for precise line alignment.
How to select and assign tools to different SP slots.
Procedure for setting the cutting depth for different tools.
Detailed steps for setting knife and wheel depths.
Adjusting the creasing wheel offset for parallelism.
Steps to configure PC network settings for data transmission.
Procedure for setting the IP address for network connection.
Setting up the MV Viewer software and camera IP address.
Interface for setting IP addresses for cutter and device.
Steps to install the DocuCutter software on a computer.
Choosing the installation directory for the software.
Confirmation of successful software installation.
Setting up the printer and cutter model in the software.
How to open and select files for printing.
Configuring unit, scale-size, and other options for opening files.
Sending the print job to the machine after setup.
Managing files in the watcher directory and print queue.
Configuring camera locator settings for registration.
Adjusting machine locator parameters for accurate positioning.
Configuration of system, code, space, and loc-type.
Defining tools for SP1 and SP2 for specific shapes.
Demonstrates adjusting gradient coefficient for cut output.
Warnings regarding factory defaults and gradient coefficient.
Solutions for alarms related to document size.
Explanation of the safety protection screen and resume function.
Troubleshooting self-detection and expired password issues.
Recommended maintenance tasks and their frequencies.
Basic specifications like model name and maximum speed.
Specifications on cutting thickness, media compatibility, and precision.
Specifications for file format, data interface, and transmission.
Details of the warranty period and service.
To Next Page
