How to fix 'Out of paper' error on Duplo DocuCutter CC-330?
If you are getting an 'Out of paper' error on your Duplo Cutter, it means the feed tray is empty. To resolve this, simply fill the feed tray with paper.
What to do if Duplo DocuCutter CC-330 shows 'check top cover' error?
If your Duplo Cutter displays a 'check top cover' error, ensure that the top cover is correctly placed in its position.
What to do if Duplo DocuCutter CC-330 shows 'check rear cover' error?
If your Duplo Cutter displays a 'check rear cover' error, ensure that the rear cover is correctly placed in its position.
Why is my Duplo Cutter miss feeding?
A Duplo Cutter may miss feed due to several reasons. You can try the following: 1. Adjust the feed tray tension. 2. Adjust the side guide if it's too tight. 3. Fan the paper and reload it into the hopper.
What to do if Duplo DocuCutter CC-330 Cutter shows 'jam sensor 2'?
If your Duplo Cutter displays a 'jam sensor 2' error, follow these steps: 1. Remove the paper jam by pulling it toward the stacking tray. 2. If double feeding occurs, adjust the feed hopper tension.
What to do if Duplo Cutter shows 'jam sensor 3'?
If your Duplo Cutter displays a 'jam sensor 3' error, here's what you can do: 1. Use the JOG key to clear the jam. 2. If double feeding happens, adjust the feed hopper tension.
Use the slitter registration adjustment knob to compensate for print shifting.
Press the JOB button repeatedly until the desired job number is displayed.
Press the ENTER button to confirm and select the displayed job.
Press the green start button to begin the cutting operation.
Press BATCH until desired count appears; increments by 10. Set 'OFF' for no count.
Press ENTER to select the desired batch count.
Press the green start button to begin operation with the set batch count.
Hold FINISHED LENGTH, press JOG+ to increment or ENTER to decrement.
Hold TOP MARGIN, press JOG+ to increment or ENTER to decrement.
Hold GUTTER, press JOG+ to increment or ENTER to decrement.
Press RESET to save the programmed settings.
After clearing jams, press RESET to clear all errors.
To Next Page
General
