ADVANCE
ADVANCE_a
ADVANCE_b ADVANCE_c
Knife Comp: Adjusts the angle of
corner cut
-If the angle is rounded, increase the
value
-If the angle has point, decrease the
value
Auto-return: Head returns to set
positions
Off= stays at its current position
after cuts
Back= goes to starting position
Max= goes to the corner of the
document
Password Input: 8888
Wheel offset: If wheel isn’t making a
straight line along the X axis. 10
units is 1
o
-Positive rotates counter clockwise
-Negative rotates clockwise
Pump enable: Automatically
turns on pump before cutting. If
OFF you are required to manually
turn ON pump before cutting.
Extended Setup button
Knife1 Comp: Adjusts the angle of
corner cut
-If the angle is rounded, increase the
value
-If the angle has point, decrease the
value
PG-enter: OFF (default)
Pump time: delays the time before
the cutter starts
2 = Default
Auto-Feed: Automatically feeds
the next sheet
Cut height: Adjusts the lift up height
of the tool
5mm= Default
To Next Page
Loading...
