Warnings:
Existed parameters of offsets are factory defaults, which is required to be followed
strictly, otherwise there would occur equipment damages and unexpected risks.
All parameters existed on the page after Enter the password are factory defaults.
Please do not alter them except under the guide of suppliers. Otherwise, may occur
unexpected equipment damages or personal injuries!
Gradient coefficient is up to +/- 2.5 degrees, uncontrolled shrinking of breadth may
occur if the coefficient is too large.
6. Q & A of Alarms
Alarm Solution
1. Cut file is over the working size of the cutting
table, please select correct machine model
on
2. Cut file is over valid work area of
To Next Page
Loading...
