Duplo DP-21S II

30
This section describes how to make prints using the basic functions.
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Turn ON the power. (
aa
aa
a See page 23, “Turning Power ON/OFF”)
Tip
• If the power is already ON, press
(ALL CLEAR) key.
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Load paper. (
aa
aa
a See page 32, “Loading and Replacing Paper.”)
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Load the document. (
aa
aa
a See page 34, “Loading
Documents”)
Adjust the slide guide to the marks for the size of the docu-
ment.
Place the document face up in the document tray.
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Select the zoom ratio.
The zoom ratio is set to 100%.
Press (ENLARGEMENT)key or (REDUCTION)key to set a desired zoom ratio. (a See page 36,
“Enlargement and Reduction”.)
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Press (PLATE MAKING) key.
When the plate has been made, one test print is automatically
made.
IMPORTANT
• The test print is for verification purposes only
and may be fainter than the final print.
Tip
•You can enter the number of desired prints
before pressing (PLATE MAKING) key to
immediately print the required number of copies.
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Basic Printmaking
T
ABC