75
5
2
1
Replacing Consumables
Replacing the Master Roll
The message “ROLL-MASTER END” is displayed on the LCD panel when the master roll is used up. Replace the
master roll using the following procedure.
IMPORTANT
• Only use a master roll designed for use in this machine.
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Open the upper cover.
IMPORTANT
• Do not touch the heat generator of thermal
head. Doing so may cause damages, leading
to a malfunction of plate making.
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Press the master cover ralease lever.
The master cover will open up.
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Lift out the master roll.
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Continue Page
•••
ROLL-MASTER END
Upper cover
Master roll
Master cover
Master cover
release lever
To Next Page
Loading...
