78
Replacing the Master Ejection Core
The message “EXCHANGE EJECT ROLL” is displayed on the LCD panel when the master ejection core is full.
Remove the master ejection core using the following procedure:
IMPORTANT
• Use only a master ejection core designed for use in this machine.
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Press the plate ejection box release lever to open
the master ejection box.
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Open the master ejection box until it stops.
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Open the cover while pressing and holding the
plate ejection box lid release lever.
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Plate ejection box release leve
To Next Page
Loading...
