Duplo DP-21S II

42
Proceed with steps 1 to 4 of the sequence described in “Basic Printmaking” (
aa
aa
a page 30).
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Press
(DOCUMENT MODE SWITCH) key
to select the desired mode.
Each time (DOCUMENT MODE SWITCH) key is
pressed, the lit document mode indicator lamp changes as
follows.
“Text” → “Text/Photograph” → “Photograph” → “Text”...
Tip
To return to “Text mode” use one of the following
two methods:
• Press (DOCUMENT MODE SWITCH) key
to select “Text”.
• Press (ALL CLEAR) key. In this case, all
settings are reset to standard mode (a page 24).
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
Start platemaking and printing. (
aa
aa
a See steps 5 to 8 of “Basic Printmaking” page 30.)
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
This section describes how to install the print tray and remove printed pages from the print tray.
STD STD
1:1
1
4
7
Text/Photograph/Txt and Photograph Mode