Duracell POWERPACK 600 - Using the Duracell Powerpack 600

Using Duracell® Powerpack 600 for the First Time
Using Duracell® Powerpack 600 for the
First Time
Important: Prior to operating your AC appliance or 12 V DC
appliance, ensure that the battery
of the Duracell® Powerpack is
fully charged.
If the battery has been fully discharged, recharging
with the AC Charger may take up to 35 hours.
Recharging with the AC Charger
Note: The Battery Charge (%) reading on the digital display is
only accurate when the Duracell® Powerpack has been
disconnected from all appliances and all charging sources for
15
minutes.
Recharging with the AC charger is a true "plug-in-and-
forget" charging method. We recommend leaving the AC
charger connected when the Duracell® Powerpack is not in
use.
To recharge with the AC Charger:
1. Disconnect any 12 V DC appliances and tum the light
off.
2. Tum the AC Outlet ON/OFF switch to OFF.
3. Plug the AC Charger into a standard AC wall outlet.
4. Insert the AC Charger cable end into the charger input
socket page 9.
The green
Charging Status light changes from flashing to
steady when charging is complete (about
35 hours if the
battery is completely discharged).
975-0339-01-01
13