Connecting
to
an External Battery
'"
WARNING:
Fire
hazard
~
Jump-start cable clamps must be connected positive to positive (red
clamp to battery
"+")
and negative to negative (black clamp to
battery
"-").
A reverse polarity connection (positive to negative)
may cause damage to the unit and/or create a sparking/explosion
hazard.
'"
WARNING:
Acid
spills
~
Use a sealed, non-spillable battery for indoor use. Common auto
and marine batteries are not suitable for indoor use unless their
fumes are vented outdoors. Common auto and marine batteries
contain acid, which is hazardous
if
spilled. Wear eye protection and
protective clothing when connecting the Duracell® Powerpack to
an external battery.
To
connect the Duracell® Powerpack to
an
external
battery
using the
jump-start
cables:
1.
Connect the cables to the jump-start cable port on the left
side
of
the Duracell® Powerpack.
2.
Connect the red positive (+) clip
of
the cables to the red
positive
(+) terminal
of
the external battery.
3.
Connect the black negative
(-)
clip
of
the cables to the
black negative
(-)
terminal
of
the external battery.
'"
WARNING:
Sparking
and
explosion
~
Do not remove the cables from the jump-start cable port when the
positive and negative clamps are connected to the terminals
of
the
external battery.
---------------------
975-0339-01-01
23
To Next Page
Loading...
