Recharging the Duracell® Powerpack 600 Battery
l'
WARNING:
Fire
and
explosion
hazard
~
Do not use this recharging method
if
your vehicle has abnormally
high voltage electrical systems that operate above
15
V DC. This
may lead to accumulations
of
hydrogen, causing exposure to fire
and explosion hazard.
l'
CAUTION
~
Do not operate AC or DC appliances while the Duracell®
Powerpack is being recharged with the DC charging cable from
your vehicle.
To
recharge
the
Duracell®
Powerpack
while you drive
using
the
DC charging cable:
1.
While the vehicle engine
is
running, plug one end
of
the
DC charging cable into the DC power socket
of
the
Duracell® Powerpack.
2.
Plug the opposite end
of
the DC charging cable into the
vehicle's lighter socket or
12
V accessory outlet.
3.
Once the Duracell® Powerpack is fully charged or
if
your vehicle's engine is not running, disconnect the DC
charging cable from both sockets.
Most
of
the capacity will be restored in four hours while
the vehicle engine
is
running.
Note: The green
Charging
Status light will not illuminate when
the Duracell® Powerpack is recharged through the DC charging
cable.
Note:
Battery
Charge
(%)
indicator is only accurate when the
Duracell® Powerpack has been disconnected from all appliances
and all charging sources for
15
minutes.
Important: Do not leave the Duracell® Powerpack permanently
connected to the vehicle's lighter socket or
12
V accessory
outlet~
975-0339-01-01
29
To Next Page
Loading...
