10 | Cleaning Your Bronco Max
GraphicProducts.com | 800-788-5572
CLEANING YOUR BRONCO MAX
Periodic cleaning of the print head, cutter blade, and platen roller will extend the life of
the printer and help maintain optimal printing quality.
IMPORTANT! Always turn the power off and disconnect Bronco Max from all
power sources before cleaning or performing maintenance. After cleaning, wait
until any liquids have fully evaporated before turning the power on again.
TO CLEAN YOUR BRONCO MAX:
1. Turn the printer off, and disconnect it from all power sources.
2. Lift the cover release latch, and raise the cover of the printer. The cover mechanism
will hold the printer open.
3. Remove the ribbon cartridge and label stock (if loaded), and place them on a clean,
flat surface.
4. Open an individually packaged
cleaning swab, or lightly moisten a
clean, soft cloth with isopropyl alcohol
(isopropanol).
5. Gently rub the swab or cloth back and
forth across the front and underside of
the print head to remove any built-up
adhesive or residue.
6. Run the swab or cloth between and
around the gray adjustable label guides
on the floor of the printer, to clear any
dust or adhesive build-up.
7. Lift the two black latches on either
side of the black rubber roller (“platen
roller”), and lift it out. (You can use the
notched end of the supply spindle to
help release the latches.) Use clean
swab or cloth to gently wipe away any
material that has stuck to the roller surface. Then, press the platen back into place,
until the latch on each side has locked it down again.
6
To Next Page
Loading...
