R
DURASTAR.COM16
TURBO ( )
Press the TURBO button to turn this feature on and off. The TURBO feature enables the unit to
reach the set temperature in the shortest time by automatically controlling the fan speed. This
feature is only available in COOL and HEAT modes.
LED ( )
Press the LED button to turn on and off the display of the indoor unit.
CLEAN ( )
Airborne bacteria can grow in the moisture that condenses around the heat exchanger in the unit.
With regular use, most of this moisture is evaporated from the unit. By pressing the CLEAN button,
your unit will clean itself automatically. After cleaning, the unit will turn off automatically. Pressing
the CLEAN button mid-cycle will cancel the operation and turn off the unit. You can use CLEAN as
often as you like. You can only activate the CLEAN function in COOL or DRY modes. This feature is
not available in multiple zone configurations.
SILENCE ( )
Press the FAN button for two (2) seconds to turn on and off the SILENCE feature.
When the SILENCE feature is activated, the compressor will slow and the
indoor unit will turn the fan to low. This will reduce the noise of the indoor unit to
the lowest level. Due to the slow operation of the compressor, it may result in
insufficient cooling and heating capacity. This feature is not available in multiple
zone configurations.
FREEZE PROTECTION (FP)
The FREEZE PROTECTION feature sets the indoor temperature to 46°F (8°C). The
unit will maintain this temperature and prevent indoor pipes and household items
from freezing when the house is unoccupied for long periods of time in the winter.
The display will show "FP" when this feature is on.
To activate, first turn the unit to HEAT mode and set the temperature to 60°F
(16°C). Then, press the DOWN (
V
) button twice (x2) in one (1) second to start the
FREEZE PROTECTION feature. Press the ON/OFF button to turn off the feature.
This feature is only available in HEAT mode.
LOCK ( )
The LOCK feature disables the remote's buttons so your settings cannot
be changed. To activate the remote LOCK feature, simultaneously press
the CLEAN and TURBO buttons for five (5) seconds. To turn off the
LOCK feature, simultaneously press CLEAN and TURBO again for five (5)
seconds.
AUTO-RESTART
The AUTO-RESTART feature is enabled when power is interrupted to the unit. After power is
restored, the unit will automatically return to its prior settings before power was lost. No buttons
need to be pressed to set this feature - it is automatic.
REFRIGERANT LEAK DETECTION (EC)
The indoor unit will automatically display “EC” when it detects a refrigerant leak. If a leak is
detected, turn off your unit and contact your dealer or certified technician for service.
This feature is not available in multiple zone configurations
2
1sec
2s
Clean
5s
5s
Turbo
+
To Next Page
Loading...
