Duratrax FireHammer MT - Transmitter Preparation; Charging the Receiver Battery

FINISHING
FINISHING
THE FIREHAMMER MT
THE FIREHAMMER MT
• Disconnect the receiver battery lead from the
ON/OFF switch lead.
• Plug the charger (included) into an electrical
outlet.
• Plug the battery into the charger.
• Charge the battery.
AA
–
+
–
+
+
–
+
–
+
–
+
–
–
+
–
+
AA
AA
AA
AA
AA
AA
AA
STTH
ST
TH
R
N
TRANSMITTER PREPARATION
RECEIVER
BATTERY
LEAD
INCLUDED
CHARGER
CHARGING THE RECEIVER BATTERY
• Install eight “AA” batteries into transmitter, making sure the polarity is correct.
• Insert the antenna into the top of the transmitter and tighten.
• Turn the transmitter on and check the battery light.
• If both LEDs light up, the batteries are acceptable. If only the red LED lights
up, immediately replace the batteries.
4