• Fully extend the transmitter antenna.
• Turn the transmitter on, then turn the receiver on.
• Turn the transmitter wheel to the right—the front wheels should turn to the right. If not, move the steering servo reverse switch.
• When running, adjust the steering trim so the truck tracks straight.
• Pull the throttle trigger to make sure the carburetor opens fully and the throttle linkage functions properly without binding.
• Adjust the throttle trim until the carb is at the idle position. Always adjust idle speed with the idle stop screw on the carb, not
the throttle trim.
• Push the trigger and roll the truck to make sure the brakes are applied.
• Decal the body to your liking. Use the
photos on the box as a reference.
• Install the body onto the chassis using
four body clips.
6
To Next Page
Loading...
