• Uncoil and straighten the antenna wire.
• Route the receiver antenna wire through
the antenna tube.
• Install the tube into the antenna mount.
• Install the antenna cap onto the top of the
antenna tube to hold the assembly in place.
• The air filter comes pre-oiled. However, after runs in dusty conditions, clean and re-oil the foam element.
• Remove the air filter top and foam element.
• Clean the foam using soap and water.
• Apply air filter oil (DTXC2465) onto the foam element, squeezing the element until it is completely coated
with the oil. TIP! Placing the element in a plastic bag will help keep your hands clean.
• Remove any excess oil with a paper towel.
• Reinstall, making sure the filter is properly seated on the base.
5
To Next Page
Loading...
