STARTING THE GENERATOR (CONTINUED)
Starting the Generator Using Recoil Start
36
Shut breaker o
The breaker is located on the right side of the front power
panel. Flip the breaker down to prevent accidental load
when starting the generator.
1.
Select your fuel.
If using gasoline, see step 2 on pg. 36. If using propane see
steps 2 - 4 on pg. 38.
2.
Close choke
The choke lever is located above the air lter to the left of
the recoil start. Slide the lever to the left to cut the air supply
and allow more gas into the engine to start.
3.
Turn engine switch to START
The key switch is located on the left side of the front power
panel. Insert the key and turn to the start position to start
the generator. Allow the key to return to the run position
once started.
4.
To Next Page
Loading...
