Dyna-Glo DGU951SDE-D - Page 11

11
ASSEMBLY INSTRUCTIONS
3. Remove the pre-installed screws on the door
handle (E) and attach the handle to the upper
door on the cabinet assembly (A) using the
pre-installed screws.
4. Remove the lower drawer assembly (J) from the
cabinet assembly (A). Remove the pre-installed
screws on the drawer handle (E) and attach the
handle to the drawer assembly (J) using the
pre-installed screws.
A
E
3
4
A
Hardware Used
AA
M4 x 35 mm
Screw
x 4
E
AA
J
Hardware Used
AA
M4 x 35 mm
Screw
x 4
AA